Operating Instructions

15GB
Cautions
• It is extremely dangerous if the cord becomes
wound around the steering column or gearstick.
Be sure to keep it and other parts from interfering
with your driving operations.
•If airbags or any other shock-absorbing
equipment are in your car, contact the store where
you purchased this unit or the car dealer before
installation.
Notes
• When mounting on the dashboard, remove the visor clip
carefully from the microphone , then attach the flat-
mount base  to the microphone .
• Before attaching the double-sided tape , clean the
surface of the dashboard with a dry cloth.
When using the steering wheel remote
control
Installation of the connection cable RC-SR1  is
required before use.
1 To enable the steering wheel remote control, select
[General]  [Steering Control]  [Custom]  to
make the registration.
When the registration is complete, the steering
wheel remote control becomes available.
Notes on installing the connection cable RC-SR1 
• Refer to the support site for details then connect each lead
properly to the appropriate leads. Making an improper
connection may damage the unit.
URL: https://www.sony.com/am/support
• Consulting the dealer or an experienced technician for
help is recommended.
When using the wired remote control
1
To enable the wired remote control, set [Steering
Control] in [General] to [Preset].
Installation of an HDMI cable (not supplied) is
required before use.
1 Connect an HDMI cable to the HDMI
terminal at the back panel of the unit.
2 Pass the cable tie  through the cable
holder, then tie the cable tie  around the
HDMI cable.
The HDMI cable is secured to the unit.
* HDMI cable (not supplied)
3 Connect the installed HDMI cable to an
HDMI device.
4 Press HOME, then touch [HDMI].
The HDMI device connected will be mirrored to
this unit.
Installation of the rear view camera (not supplied) is
required before use.
The picture from a rear view camera connected to
the CAMERA IN terminal is displayed when:
– the back lamp of your car lights up (or the shift
lever is set to the R (reverse) position).
– you press HOME, then touch [Rear Camera].
Using the wired remote control
Using an HDMI device
Using the rear view camera
*
