Help Guide (Web manual)

Sliding type

Push-release type

There may be poor contact between the battery and the remote control. Remove the batteries, then

insert them again.

Point the remote control at the remote control sensor located at the front of the TV.

Keep the remote control sensor area clear from obstacles.

Fluorescent light can interfere with remote control operation; try turning off any fluorescent light.

When you unplug the TV and plug it in again, the TV may not be able to turn on for a while, even if

you press the power button on the remote control or the TV. This is because it takes time to

initialize the system. Wait for about 10 to 20 seconds, then try again.

When your voice is not being recognized, make sure to activate the button on the remote

control with the

button, or register the remote control with the button to your TV. To confirm

these settings, press the HOME button, then select [Settings] — [Voice Remote Control]. The

button may not be available depending on your supplied remote control.

[149] Troubleshooting | Remote control/accessories

You cannot turn the Active 3D Glasses on. (3D

models only)

Replace the battery. (Applies only to TDG-BT400A/BT500A.)

Press the unlock button with the tip of a pen, etc., and take out the

battery case.

108