User Manual

12
US
 REMOTE RS-232C
REMOTE IR IN
• These jacks are for receiving the
external control signal. Enables
extended control of the TV using RS-
232C via the RS-232C and IR IN jacks.
RS-232C: connect to the RS-232C
t
ermin
al of the home controller.
IR IN: connect to the IR out terminal
of the h
ome controller.
• Take care to not connect to
he
ad
p
h
o
nes or an external audio
system.
/ VIDEO IN
• For a composite connection, use an
Analog Extension Cable (not
supplied).
•
 AUDIO OUT /
• Supports 3-pole stereo mini jack only.
• To listen to the TV's sound through
the conn
ected equipment, press
HOME. Select [Settings]  [Sound]
 [Headphone/Audio out] and then
select the desired item.
 IR BLASTER
• Use your Sony remote control to
control your Set Top Box (cable/
satellite box). Connect the IR Blaster
Cable (supplied) to the IR Blaster port
on your TV. Place one or both of the
other two ends as shown below.
• To perform IR Blaster setup, press
HO
ME and
select [Settings] 
[External inputs]  [IR Blaster setup].
 USB 1/2, USB 3
• Connecting a large USB device may
interfere with other connected
devices beside it.
• When connecting a large USB device,
c
onnec
t to the USB 1 port.
 HDMI IN 1/2/3/4
• HDMI interface can transfer the digital
video and audio on a single cable.
•
• HDMI IN 2/3
To enjoy high quality 4K 60p
contents,
connect a Premium High
Speed HDMI cable to the HDMI IN 2/3
and set the [HDMI signal format] to
[Enhanced format].
For details of supported formats, refer
to
the “Spec
ifications“ in this manual
(page 21-22).
• H
DMI IN 3 ARC (Audio Return
Chann
el)
Connect your audio system to the
HDMI IN 3 to route TV audio to your
au
dio sy
stem. An audio system that
supports HDMI ARC can send video to
the TV, and receive audio from the TV
via the same HDMI cable. If your
audio system does not support HDMI
ARC, an additional connection with
DIGITAL AUDIO OUT (OPTICAL) is
necessary.
3.5 mm
1234
1: L
2: Video
3: Ground
4: R
< 12 mm
< 21 mm