User guide

Form 1547 (10.13) ©SOR Inc.

5/8

Once the switch is installed and wired into a control or display loop, it is ready for use.

Before applying power, check that the polarity and excitation voltage are correct.

Single Point: Close on Rise/Open on Fall – In this configuration, the switch output

will be open for pressures less than the selected setpoint. The switch output would

then be closed for pressures greater than the setpoint. (

See

)

Single Point: Open on Rise/Close on Fall – In this configuration, the switch output

will be closed for pressures less than the selected setpoint. The switch output would

then be open for pressures greater than the setpoint. (

See

)

Window Mode