Instruction Manual

2/8

Linear = mm/inches

Dimensions are for reference only.

Contact the factory

for certified drawings

for a particular model number.

Calibration

The transmitter is supplied factory calibrated and during normal use should not require

recalibration. If it is desired to verify calibration prior to installa tion of Series 510LT,

remove the nose cone and attach to a pressure source capable of adjustment

throughout specified range. If outputs are not within limits at factory calibration

conditions, 77°F (25°C), the device should be returned to the factory.

Units in hazardous locations - prior to removal from service, make sure

that the work area is declassi ed.m Failure to do so could result in severe

personal injury or substantial property damage.

Drawing 0091085

Drawing 0091268