User's Manual

Wireless communication – The Smart Spot is
designed for use with a mobile phone network. It
is intended to transmit your personal data using a
mobile phone operator. The operator and number to
call are pre-configured, there is nothing to set up.
Check button – Do not press the Check button on
the bottom of the Smart Spot unless requested to do
so by our MicroPort technical assistance.
Interference – Using Smart Spot may potentially
disturb your TV. You are advised to switch off the
TV while using Smart Spot.
5. FAMILIARIZE YOURSELF WITH
YOUR SMART SPOT
5.1. PACKAGE CONTENTS
Inside the box you will find:
1 Smart Spot
Silicon sleeve (do not remove from the USB
connector)
User manual
1 Power supply (European plug) with telemetry
head
― 1 Power adaptor for United Kingdom
― 1 Power adaptor for Australia
― 1 Power adaptor for Japan / United States
Do not use any other parts than those
supplied with the Smart Spot, as this may
result in increased emissions or decreased
immunity of the equipment.
5.2. DESCRIPTION OF CONTENTS
A: Patient Initiated Transfer button (PIT button).
B:Progression lights.
C: Status light. D:Power supply inlet (cable with the
orange mark).
E: The array of blue LEDs is a locator.
F: The whole underside is a Type BF applied part.
6. USING YOUR SMART SPOT
The Smart Spot can only be used upon your
doctor’s request.
6.1. NORMAL FUNCTIONING
In order to use your Smart Spot quickly, easily and
safely, follow the instructions in the table below.
If you need any help please call our technical
assistance (see phone numbers in the separate
leaflet). Our technicians will assist you. It takes little
time.
1. Take all the items out of the box.
2. Place the Smart Spot in a stable position.
3. Plug the end of the cable with the orange mark
into the appropriate inlet in the Smart Spot
identified with the same orange mark.
For continued IP21 protection (solid and liquid body
intrusions protection), do not remove the silicon
sleeve from the USB connector.
4 Smart Spot – UA10275A