Installation Guide

8 9
10
11
Do not actuate the Linear-Cam by pushing it in or by actuating the
Racks.
The Linear Cam must be in the forward position to be installed.
If by accident you have done so, then you must reposition the
Chassis Spring as shown at right using needle nose pliers or a small,
flat blade screwdriver.
Important Note
Install Bolt Assembly
Install bolt assembly through outside
edge of door. Tapered end of bolt should
face the strike plate in the jamb. Attach
face plate (1" or 1
1
/8"), snap on to bolt
assembly short shell.
Attach with screws.
Installation of Chassis Assembly
Remove Linear Cam Shipping pin
with yellow flag
from Unirose
with needle
nose pliers.
Insert Push Side Unirose into door, slightly
depressing the linear cam to clear the 2
1
/8" hole.
When Push Side is approximately
1
/4" from face
of door, push bolt inwards to depress retention
clip, allowing linear cam to engage into slot
in bolt. It should click into place with the Bolt
Assembly. Manually test to ensure bolt action
works freely.
Attach Pull Side Unirose
Secure with 3 screws to snug.
Test bolt action again. Check
for level with Torpedo Level,
if correct, tighten the screws
with #2 Phillips screwdriver. If
your UltraLatch® is equipped
with a Privacy Lock, the lever
will be facing the right. Turn
the locking shaft on the Push
side to the right (Clockwise).
(To test the bolt, on the PULL
SIDE of door, push the rack,
on the PUSH SIDE of the door,
pull rack to test).
Remove the following from your Hardware Bag: 2 each of the Handle
Pivot Screws, 2 each of the Handle Shaft and 2 each of the Cover Screws.
Install Handle Shafts into racks.
Make sure they are centered
on each side.
Install Rose Covers
w/cover screws.
Install Handles
When installing handles, the
offset side of the handle must
face the hinge side of the door
(see diagram at right).
Install PUSH SIDE
Handle. Place
handle almost
flat sliding over
handle shaft.
Tip forward,
insert Pivot Pin
and tighten with
T-15 6-Lobe
Screwdriver.
Repeat procedure on
the PULL Side handle
Handle Pivot Pins
come with thread
locking material
preapplied.
We recommend
a 72 hour period
before excessive
use of door,
to allow
thread locking
material to cure.
Test to ensure system works freely.
Congratulations, your installation is complete!
3
Pin
Pin Retracted
Correct, Ready to InstallIncorrect, Not Ready to Install
Chassis Assembly