SL300 Elite Hi-Definition Noise Cancelling Headphone
Compliance with FCC rules (U.S.A., only) This device complies with Part 15 of the FCC rules. Operation is subject to the following two conditions: (1) This device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation. NOTICE This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC rules.
Safety Information English Please read this owner’s and product guide Readingthis Reading thisguide guidewill willensure ensure proper proper and and safe safe useuse of your of your Soul® Soul® headphones. headphones. Follow Follow all operation all operation guidelines guidelines and adhere and adhere to all safety to allwarnings safety warnings and cautions. and cautions. ! ! Warning UseWarning your headphones responsibly.
Battery Precautions • Keep batteries out of the reach of children. • Use only disposable AAA alkaline batteries. • Do not use rechargeable batteries. • Observe correct polarity as marked. • Remove depleted battery immediately. • Please dispose of used batteries properly. • Do not use a leaking battery. If battery leakage occurs, avoid contact with skin. If contact occurs, immediately wash thoroughly with soap and water.
! Caution DO NOT operate any motor vehicle or heavy machinery while listening to or wearing your headphones. Doing so is not only dangerous to you or others but illegal in many states. Listening or wearing headphones reduces your ability to hear sounds around you such asemergency vehicle sirens or the horn from another motorist. It is not recommended to use headphones when cycling, running or walking in heavy traffic areas, where your full attention is necessary for your safety.
At A Glance 1. SL300 Headphone 2. Ear cup 3. Adjustable Headband 4. Audio Cable Input Jack 5. iPhone®, iPod® and iPad® control switch 6. 1/8” (3.5mm) Gold Plated Plug 7. Active Noise Cancelling Power Slide Switch 8. Headphone Badge Light Button 9. Battery Compartment 10. Hi/Lo Output Switch 1 2 4 10 9 3 8 5 7 6 Box Contents SL300 Headphones Detachable Tangle-Free Audio Cable with In-Line Remote Control 1/8” (3.
Using Your Soul® Headphones Carefully remove your Soul® headphones from the protective storage road case. You will find the audio cables, adapters and cleaning cloth in the accessory box directly below the headphones. Gently open the headphones all the way one side at a time until you feel them lock into place. Headband Adjustment Your Soul® headphones are fully adjustable for the most comfortable fit. Firmly hold the top headband with one hand and the bottom headphone portion with the other.
Installing the Batteries and Selecting the Hi/Lo Output Please take the two AAA batteries included with your accessories and remove the protective plastic shrink wrap. On the right side of your headphones is the battery compartment. Place your thumbs as illustrated in the diagram below on both sides of the battery door (Logo Plate). You will notice two dimples opposite of each other as a guide. Gently press down on the battery door and turn to the left (counter-clockwise) about 1/8”.
Warning Use your headphones responsibly. Exposure to excessively loud noise can cause Noise Induced Hearing Loss (NIHL) ! Caution Do not over tighten or apply too much pressure to the battery cover as you could break the locking tabs. Headphone Maintenance Your Soul® headphones include a soft cleaning cloth located in the accessory box. Use the cloth to remove any fingerprints, oily residue or dirt from the headphone.
Using Your Soul® Headphones Once you have found the proper fit, the audio cable has been connected, batteries have been Installed and you have selected the Hi/Lo output you are ready to start enjoying the full range and quality of your Soul® headphones. 1. Place headphones over your ears. Note: the headphones have an “L” for Left and “R” for Right indicators on the inside bottom portion of the headband.
In-Line Remote Control Function and Diagram Top For Controlling Phone Functions x3 x2 x1 • 1. Answer/Hang Up – During an incoming call press and release the center button ( ) once to answer the call. Once you have completed your call press and release the center button once again to hang up the phone. 2. Call Rejection – If you do not want to answer an incoming call, you can hold the center button for approximately two seconds.
For Controlling Music or Movie Functions Top x3 x2 x1 1. Volume Control – When you want to increase the volume of your phone or multimedia device press the up arrow ( ) on your in-line controller. Note: Make sure to increase volume slowly to prevent damage to your hearing. When you want to decrease the volume, press the down arrow ( ) on! your controller. ! • 2. Play or Pause – To play a song or video, press and release the center button ( ) once.
In-Line Controller Compatibility Guide The following Apple models should have full functionality of the controller. iPhone® 4S, iPhone® 4, and iPhone® 3Gs, iPad®2 Wi-Fi, iPad®2 3G, iPad® Wi-Fi and iPad® 3G, iPod Touch® 4th Generation, iPod Touch® 3rd Generation and iPod Touch® 2nd Generation, iPod Nano® 6th Generation, iPod Nano® 5th Generation and iPod Nano® 4th Generation, iPod Classic®. For Android™ or BlackBerry® models, not all in-line controller functions may fully work.
Trouble Shooting Guide Problem Solution No Sound Check plug; make sure it is plugged in all the way. Check volume level, increase volume if necessary. Check power, make sure device is on. Check in-line controller, press center button to ensure it is not on Pause. Low Volume Level Make sure that the headphones are creating a proper seal around your ears. Increase the volume level on your device. Make sure that the Hi/Lo switch located In the battery compartment Is set to Hi.