Users Manual

4. Testing
① The battery have been installed before delivery
② This product works only in smart applications certified and provided by SOUL2ON Inc.
③ This product is registered the system server, so no separate registration is required.
④ Run the smart application before testing and wait for a response signal.
⑤ Press ‘No.3 (O)’ Button of this product away from the smart device running the application.
⑥ If the identification number of the product is displayed in the smart application, it is
working normally. (The wireless signal transmission of this product may be affected by
large objects or structural materials.)
5. Battery Replacement
-When signal transmission is weakened or LED Light dimmed, user need to buy replacement
batteries (Type: R2032 3V lithium battery)
-How to replace the battery of this product is as follows.
① Remove the small screw on the back of the product.
② Use a Phillips screwdriver and be careful not to lose the screws.
③ After removing the screw, open the rear cover and remove the old battery.
④ Insert the new battery (make sure the positive (+) side is on the outside as shown).
⑤ Install the rear cover and hook ring and secure with screws.
⑥ If you press any button on this product, the LED indicator lights up and the test and
replacement is completed.
6. System Limitations
The Wireless Response Device (SRC10-BLE) have been developed very reliable. However, you
should be careful because the following situations can occur.
① The signal is interrupted when the frequency range of the application device receiving
this product's signal is out of range.
② Before using a smart application, the wireless device should be periodically checked for
abnormal operation It is recommended that you check that there is no.
(3) If the voltage of the smart application device is unstable or the battery voltage of the
wireless response device is low Signal transmission failure may occur.
Battery Pole (+)
Screw Holes
Hanging Ring
Battery Clip
Battery
Removing
Direction