User Manual

302 User Guide and Technical Information

The Setup Menu

The 302 has 18 available setup features. See the Setup Menu Chart for all available options. Setups,

typically set-and-forget features, are infrequently changed. With the Setup Menu, these features are

easily accessed directly on mixer’s the front panel.

Entering the Setup Menu

To access the Setup Menu perform the following steps:

1. Turn off the mixer, if already on.

2. Press and hold the Peak/VU selection switch while switching power on.

3. The Setup Menu is now entered.

Press and hold while

powering on to enter the

Setup Menu; also used to

advance to the next Setup

Menu option

Functions as the “down”

button when in a setup

Functions as the “up”

button when in a setup

The mixer will not pass audio when in the Setup Menu. When in the Setup Menu the ﬂashing

LED on the left meter (L) position indicates the selected setup feature. The right meter (R) position

indicates the values selected for the setup. Use the PK/VU button advance from one setup to

another. If the intended setup is passed, setup mode must be re-entered since you can only step

forward through the Setup Menu.

To adjust values, the meter brightness button (down) and the battery check button (up) allow

selection among setup values. Some setups have multiple values while others have only two values.

Setup Example

The following steps show how to change the tone frequency from the factory default of 1 kHz to 100

Hz.

1. Enter the setup menu by pressing and holding down the PK/VU button while powering the

mixer. Hold the button until the –30 LED begins ﬂashing.

2. Press the PK/VU button six times until the left meter LED ﬂashes at the –16 position (see

Setup Chart for a list of all setups).

3. To move among parameter values, press the brightness button (down) and battery check

button (up) until the 100 Hz position is selected (–24 LED will illuminate solid).

4. Press the PK/VU button multiple times until the meters perform their scrolling dance. This

saves the new setting into memory.

To save new values to memory, the PK/VU button must be repeatedly pressed until the last setup is

reached. At that point the meters will “dance” and the new values will be saved to memory.