User Manual

L, R, and ISO track routings to X3 and X4 can be set to pre- or post-fader. This setting is independent

of the values set in Setup Menu option INPUTS > Input to ISO Routing. The All ISO Tracks option on

this routing screen globally applies pre- or post-fade status to all ISO track routings to X3 and X4.

The Headphone Source in the X3, X4 Routing Screen is a special source which is a copy of the active

Headphone Source. Changing the Headphone Source will change the Headphone L and Headphone

R sources routed to X3 and/or X4 (See “Headphone Source Selection”, page 22). This feature is useful

for sending a copy of the monitor signal to a boom operator or other production members.

RTN signal can not be routed to X3 and X4 buses. When Headphone signal is routed to X3 or X4 and

RTN signal is routed to the headphone preset, RTN signal will be present in the headphone output but

not in X3 or X4.

AES3 Digital Outputs (XLR-3M)

There is a total of 4 available channels of digital output on 2 connections. Each of the XLR-

3M outputs can be conﬁgured to output AES3 digital signals from the Setup Menu options

OUTPUTS > XLR-R Out and OUTPUTS > XLR-L Out.

Any track can be routed to any AES output in any combination. ISO Tracks are routed to

AES outputs pre- or post-fader depending on the Input’s setting in Setup Menu section

INPUTS > Input to ISO Routing.

Signal is routed to the AES outputs from the AES Output Routing Screen (See “Routing

Screens”, page 13). The AES Output Routing Screen is accessed from Setup Menu option

OUTPUTS > AES Output Routing.

Output Setup and Control

633 User Guide and Technical Information