User Manual

User Guide
14
Pag e Sub-menu Description
1 Solo
*
Lets you solo the selected channel in the headphone output. Soloing
by default is Individual (exclusive) in that only one input at a time
will be soloed. When a channel is soloed, its light ring will ash
orange. Soloing can be set to Multiple (non-exclusive) in the HP
Preset submenu.
1 Arm
*
Allows pre-fade recording of the channel to its own isolated (ISO)
track on the SD card.
1 Gain
*
Sets the sensitivity of the input. Generally, the gain should be set
so that the loudest parts of the audio signal just touch the red
segments of the meters.
1 Pan Lets you position the channel’s audio in the stereo image of the LR
mix and stereo out.
2 Input Lets you select one of the available Mic, Line, or USB inputs to route
to the chosen channel.
2 Phantom Lets you apply full 48v phantom power to the channel’s mic or line
input.
2 Low Cut Sometimes referred to as a high pass lter (HPF), the Low Cut lter
can be set up to roll o bass frequencies or reduce mic handling
noise, wind noise, and other undesirable low frequencies. The lter
has a carefully crafted 18 dB/octave slope.
2 Linking
*
Lets you link channels 1 and 2, either as a stereo pair or mid-side
pair.
* Sub-menu/setting appears in Advanced mode only
To enter the Channel screen:
X Press the associated Channel knob.