Owner manual

PIX 270i User Guide and Technical Information

External Control

current versions of Chrome and Safari. Multiple PIX 270i’s can be accessed at the same time from the

same web browser window using tabs.

PIXNET only supports a single client (browser) connection to a PIX 270i at one time. Accessing

PIXNET on a single PIX 270i from multiple clients simultaneously is not supported. Control access to

PIX 270i units with Setup Menu option [Network - Authentication].

The PIX 270i’s web IP address must be determined before accessing PIXNET:

1. Make sure that the PIX 270i is powered on and connected to a network or directly to a com-

puter via one of the rear panel Ethernet connectors.

2. The PIX 270i must have a unique name when controlling multiple PIX 270i units via PIXNET.

Verify that the PIX 270i has a unique name in [Network - This PIX’s Name].

3. The PIX 270i can automatically nd a unique IP Address when

[Network - Auto IP Settings] is set to On. This is the recommended method for seing

up IP connections on the PIX 270i. If needed, the IP seings can be manually entered. To

manually enter IP seings, set [Network - Auto IP Settings] to Off. Then manually en-

ter [Network - IP Address - Subnet Mask -Gateway] values.

4. PIXNET supports connection to a single client. Control access to the PIX 270i by conguring a

user name and password from Setup Menu option [Network - Authentication].

5. Open the web browser and enter the IP address displayed on the PIX 270i OSD or listed in

[Network - IP Address] into the web browser’s address bar. Enter the credentials supplied in

step 4 when prompted.