Owner manual

PIX 270i User Guide and Technical Information
v. 2.10 Features and specifications are subject to change. Visit www.sounddevices.com for the latest documentation.
56
External Control
5) Armed Track (On)
Track is armed with an active input
source and will be written during record-
ing. Click to unarm.
6) Unarmed Track
Track is not armed. Click to arm.
7) Armed Track (Off)
Track is armed with input source set to
Off and will be not be recorded. Click to
unarm.
Audio Output Matrix
When Output Matrix is selected, a comprehensive track-to-output matrix appears. From this view
route any track to any output.
TC Menu
Timecode/Sync Setup Menu settings are displayed and can be edited directly from the web browser.
OSD Menu
Timecode/Sync Setup Menu settings are displayed and can be edited directly from the web browser.
Remote Menu
Remote Control Setup Menu settings are displayed and can be edited directly from the web brows-
er.
Network Menu
Network Setup Menu settings are displayed and can be edited directly from the web browser.
Changing settings in this menu can disconnect the web browser from PIXNET
System Menu
System Setup Menu settings are displayed and can be edited directly from the web browser.
Triggering Recording from External Timecode
The PIX 270i can be configured to start recordings when incoming timecode begins rolling and stop
when it becomes stationary. This is generally referred to as Record Run timecode. The master time-
code device should be setup in this manner. To configure the PIX 270i to follow Record Run com-
mands:
1. Set Setup Menu option [Remote Control - Rec Start/Stop] to Timecode.
2. Make sure that the device that is sending timecode is congured to send stationary
timecode while stopped and running timecode while recording. To cause the PIX 270i
to stop recording when linear timecode signal is absent (disconnected), set Setup Menu option
[Timecode/Sync - Timecode Mode] to Ext TC (LTC Halt).
3. Some cameras do not send the correct timecode in the rst few seconds of a recording, or
they send short bursts of timecode causing the PIX 270i to record short unintentional les or
incorrect timecode values. The [Timecode/Sync - Auto Record Hold Off] feature is designed
to eliminate these issues. When a hold o value is applied, the PIX 270i will begin capturing
the moment timecode begins rolling but will only go into record if a valid timecode signal is
present after the hold o time has elapsed.