Owner manual

PIX 270i User Guide and Technical Information
79
Setup Menu Options
Remote Control
# Parameter Name Description Options
1
RS-422
Enable or disable RS-422 capability
• On
» Off
2
RS422 Interface Device ID
Set the DeviceID communicated to attached RS422
controllers.
» Sony BVW75
• Sound Devices
3
Rec Start/Stop
Determines what method the PIX 270i uses to auto-
matically start and stop recordings.
» Off
• SDI Flag - RED
• SDI Flag - Panasonic
• SDI Flag - Panasonic (Varicam)
• SDI Flag - Canon
• SDI Flag - Sony
• SDI Flag - Arri
• SDI Flag - PIX
• Timecode
4
GPIO Inputs
Set GPIO inputs (pins 1, 2, and 3 on GPIO connector)
to active high or active low. Active high: Connecting
the pin to +5V will activate the function. Active low:
Connecting the pin to ground will activate the function.
» Active low
• Active high
5
GPIO Outputs
Set GPIO outputs (pins 6, 7, and 8 on GPIO connec-
tor) to active high or active low. Active high: When the
function is true, +5V will appear on the pin. Active low:
When the function is true, the pin will be grounded.
• Active low
» Active high
Network
# Parameter Name Description Options
1
This PIX’s Name
Sets name of PIX 270i. This must be unique within a
network.
» PIX270
2
Grouping
Sub-menu for network grouping settings.
2.1
Network Group
Groups with other PIX 250i, PIX 260i, PIX 270i, and
970 units on the network.
» No Group
• Group 1
• Group 2
• Group 3
• Group 4
2.2
Push Settings to Group
Copies this unit’s settings to all other units in the
group. All grouped settings will be pushed. (See
“Grouped Settings”, page 47)
2.3
Synchronize audio channel
settings
3
Dante Redundancy Mode
When On the PIX 270i’s Primary and Secondary
Ethernet ports both transmit Dante Audio over sepa-
rate networks. This provides a fail safe of the Dante
system if one of the networks should fail. In Dante
Redundancy Mode, two separate networks
must be run and they CANNOT be connect-
ed to one another. Connect any computer
running Dante Controller to the PIX 270i’s
PRI Ethernet network.
» Off
• On
4
Auto IP Settings
When On, the IP settings will automatically be pro-
vided by a DHCP (recommended), or Link-local when
no DHCP is present. When Off the IP Address, Subnet
Mask, and Gateway will have to be entered manually.
• Off
» On
5
IP Address
Displays IP Address, can be edited when Auto IP
Settings is OFF.