Owner's Manual
Table Of Contents
- _000_Cover_2.03
- _001_Information_2.04
- _002_Contents_2.03
- 1.0 Introduction_2.04
- 2.0 Getting Started_2.03
- 3.0 Assignable Controls_2.03
- 4.0 Touch Screen_2.03
- 5.0 Inputs And Outputs_2.04
- 6.0 Channels And Busses_2.03
- 7.0 DSP Elements_2.03
- 8.0 Mix Features_2.03
- 9.0 Shows, Cuelist, Snapshots_2.03
- 10.0 Lexicon FX_2.03
- 11.0 Preferences, System, Security_2.03
- 12.0 Oscillator_2.03
- APP01_No Sound_2.03
User Manual
5.1.1: SOUNDWEB CONTROL
INPUTS AND OUTPUTS > PATCHING > SOUNDWEB
5.1.1: INPUTS & OUTPUTS > PATCHING > SOUNDWEB
External Control Status.
Disable / Enable Soundweb London Preamp control for this patch.
If enabled, this will activate MIC GAIN* and 48V control from the console on that input channel for the associated
Soundweb London device. If Disabled, it will deactivate the MIC GAIN and 48V control from the console, but will
keep all the settings (Node Address, Input Card, Input Channel) and the last set gain value.
Node Address
Set the Soundweb London devices’ node address to send and receive HiQnet values to your Si
console.
The node address can be found and adjusted in London Architect and Audio Architect software platforms. It is
important to note that the Node Address value in the Si console must be given in decimal format rather than
hexadecimal format.
Input Card
Select an input card on the Soundweb London device.
There are four fixed entries: A, B, C, D. Choosing A, for example, will allow you to control one of the input channels
on the Soundweb London’s A input card.
Input Channel
Select an input channel on the selected card and device.