Owner's Manual
Table Of Contents
- _000_Cover_2.03
- _001_Information_2.04
- _002_Contents_2.03
- 1.0 Introduction_2.04
- 2.0 Getting Started_2.03
- 3.0 Assignable Controls_2.03
- 4.0 Touch Screen_2.03
- 5.0 Inputs And Outputs_2.04
- 6.0 Channels And Busses_2.03
- 7.0 DSP Elements_2.03
- 8.0 Mix Features_2.03
- 9.0 Shows, Cuelist, Snapshots_2.03
- 10.0 Lexicon FX_2.03
- 11.0 Preferences, System, Security_2.03
- 12.0 Oscillator_2.03
- APP01_No Sound_2.03
User Manual
10.1.1: REVERB PARAMETERS
LEXICON FX > REVERBS > REVERB PARAMETERS
10.1.1: LEXICON FX > REVERBS > REVERB PARAMETERS
Shape
Adjust the 'contour' of the reverberation envelope.
With Shape all the way down, reverberation builds explosively, and decays quickly. As Shape is advanced, rever-
beration builds up more slowly and sustains for the time set by Spread. With Shape in the middle, the build-up
and sustain of the reverberation envelope emulates a large concert hall (assuming that Spread is at least halfway
up, and that Size is 30 meters or larger).
Spread
Adjust reverb onset and sustain.
Low Spread settings result in a rapid onset of reverberation at the beginning of the envelope, with little or no
sustain. Higher settings spread out both the build-up and sustain.
Diff - Diffusion
Initial echo density.
High settings of Diusion result in high initial echo density, and low settings cause low initial density. In a re-
al-world situation, irregular walls cause high diusion, while large flat walls cause low diusion. For drums and
percussion, try using higher Diusion settings.
Bass Bst - Bass Boost
Boost or cut frequencies below the Bass Boost Frequency (the transition point from Mid Rt
to Low Rt).
The amount of boost or cut required is highly dependent on the material being processed.
RT Hi Cut - Reverb Time High Cut
Set the frequency of a 6dB/octave low-pass lter on the reverberated signal.
It does not attenuate the reflections. High frequencies are often rolled o with this parameter, resulting in more
natural-sounding reverberation. Setting a low frequency for this parameter can actually shorten the reverb time,
as it damps the audio as it recirculates.
Hi Cut
Adjust the amount of high frequency content in the reverberation tails.
Higher frequency settings increase high frequency response, creating brighter reverbs; lower frequency settings
create darker reverbs with more bass frequency emphasis.
Hi Cut
Adjust the amount of high frequency content in the reverberation tails.
Higher frequency settings increase high frequency response, creating brighter reverbs; lower frequency settings
create darker reverbs with more bass frequency emphasis.