Operation Manual

1. Connecting up your loudspeakers to the GigRac

Note: Make sure your GigRac is not powered up. This

is very important to prevent any damage to either the

GigRac or your loudspeakers!

Using good quality speaker cables connect the loudspeakers to the

Speaker outputs on the rear of the GigRac.

If you have cables equipped with Neutrik Speakon® connectors then use

the Speakon® connectors on the rear of the GigRac. Alternatively if

you have cables equipped with jack plugs then use the jack sockets on

the rear of the GigRac.

Make sure that the Main Master Volume control (1 - see the key on

page 9) and the Monitor (Mon) Master Volume control (2) are turned

fully down.

Decide if you want to configure the 2 internal amplifiers to work as a

stereo pair, or mono mix and monitor. Set the amplifier source select

switch (3) as desired. It is assumed in these quick start instructions

that you have configured the amps as a stereo pair.

Now switch the GigRac on using the Power switch on the rear of the

unit.

2. Plugging in a vocal microphone

Note: Before connecting a microphone to channels 1-4,

make sure that the 48V phantom power switch (4) is

switched off (The red LED should not be illuminated).

Connect the microphone cable to one of the first four inputs on the

front of the GigRac (5).

(The inputs on the GigRac can receive either 3-Pin XLR or standard

Jack connectors.)