Operation Manual

1. Connecting up your loudspeakers to the GigRac

Note: Make sure your GigRac is not powered up. This

is very important to prevent any damage to either the

GigRac or your loudspeakers!

Using good quality speaker cables connect the loudspeakers to the

Speaker outputs on the rear of the GigRac.

If you have cables equipped with Neutrik Speakon connectors then use

the Speakon connectors on the rear of the GigRac. Alternatively if you

have cables equipped with jack plugs then use the jack sockets on the

rear of the GigRac.

Note: Because the GigRac 300 and GigRac 600 are

mono mixers there is no difference between the signals

sent to the Left or Right speakers i.e. both speakers

will receive the same signal equally all of the time.

Make sure that the Main Master Volume control (1) is turned fully down

Now switch the GigRac on using the Power switch on the rear of the

unit.

2. Plugging in a vocal microphone

Note: Before connecting a microphone to channels 1-4,

make sure that the 48V phantom power switch is

switched off (The red LED should not be illuminated)

Connect the microphone cable to one of the first four inputs on the

front of the GigRac.

(The inputs on the GigRac can receive either 3-Pin XLR or standard Jack

connectors.)