Operation Manual

Rear Panel GigRac 600Rear Panel GigRac 600

Rear Panel GigRac 600

(1) Power Switch

This switch turns the GigRac On or Off. The red Power LED (13) on the

front panel will illuminate to confirm this.

NB! Before switching the GigRac On or Off, make sure

that the Main and Mon Master Volume controls are

turned fully down.

(2) Power Socket

Connect the supplied power cable to this socket.

(3) Speakers Outputs (Amp 1 and Amp 2)

The Speaker Outputs are available as Neutrik Speakon connectors and

standard ¼” Jack connectors.

Connect your loudspeakers to these outputs. The signal sent to the

Speakon connectors and the Jack sockets is exactly the same.

Use the appropriate connector type to match the input connectors on

your loudspeakers. The GigRac 600 is designed to work with loudspeakers

rated at either 8 ohms or 4 ohms.

The minimum load that either of the amplifiers inside the GigRac 600

should be presented with is 4 ohms. this means that a single 4 or 8 ohm

speaker can be connected to each amplifier outputs as shown in Fig 1.

Alternatively, two 8 ohm speakers can be connected in parallel to each

amplifier output, as shown in Fig 2. Two speakers connected like this

gives a combined load of 4 ohms.