Operation Manual

Rear Panel GigRac 300Rear Panel GigRac 300

Rear Panel GigRac 300

(1) Power Switch

This switch turns the GigRac On or Off. The red Power LED (13) on the

front panel will illuminate to confirm this.

NB! Before switching the GigRac On or Off, make sure

that the Main and Mon Master Volume controls are

turned fully down.

(2) Power Socket

Connect the supplied power cable to this socket.

(3) Speakers Outputs

The Speaker Outputs are available as Neutrik Speakon connectors and

standard ¼” Jack connectors.

Connect your loudspeakers to these outputs. The signal sent to the

Speakon connectors and the Jack sockets is exactly the same.

Use the appropriate connector type to match the input connectors on

your loudspeakers.

The minimum load that the amplifier inside the GigRac should be presented

with is 4 ohms. This means that a single 8 ohm speaker can be connected

to each of the speaker outputs as shown in Fig1, or two 8 ohm speakers

can be connected in parallel to one of the speaker outputs as shown in

Fig 2. Two speakers connected like this gives a combined load of 4

ohms.