Operation Manual

USER GUIDE
20
9
FADER
The 100mm FADER gives you smooth control of the overall signal level in the channel strip, allowing precise
balancing of the various source signals being mixed to the Master Section. It is important that the input
level is set correctly to give maximum travel on the fader which should normally be used at around the `0’
mark. See the `Initial Set Up’ section on page 23 for help in setting the right level.
0
PFL
When the latching PFL switch is pressed, the pre-fade signal is fed in mono to the headphones, control
room output and meters, where it replaces the MIX. The PFL/AFL LED on the Master section illuminates to
warn that a PFL is active. The Left and Right meters display the PFL signal in mono. This is a useful way of
listening to any required input signal without interrupting the main mix, for making adjustments or tracing
problems.
q
RETURN PEAK LED
This LED will light when the return input signal peaks (+18dBu internal).
w
CHANNEL PEAK LED
This LED will light when the signal peaks (+18dBu internal). There is a three point signal analysis, and if the
signal peaks at any of these points then the LED will light:
a) PRE-EQ
b) POST-EQ
c) POST-FADE
e
SIGNAL PRESENT LED
This LED will light when the channel signal exceeds -20dBu.
r
AUX OUTPUTS (1-4)
These outputs are on 3-pole ‘A’ gauge jacks and are balanced outputs