User manual

NOTEPAD 5, 8FX, 12FX

INFORMATION

IMPORTANT

Please read this manual carefully before using your mixer

for the rst time.

This equipment complies with the Electromagnetic Compatibility directive 2014/30/EU and LVD 2014/35/EU.

This product is approved to safety standards:

IEC60065:2014 (Eighth Edition)

EN60065:2014

UL60065 2015 Ed. 8

CAN/CSA-E60065:2016 Ed. 2

And EMC standards:

EN55032: 2012+AC: 2013 Electromagnetic Compatibility of multimedia equipment - emissions requirements

EN61000-3-2:2014 Electromagnetic Compatibility - Part 3-2: Limits for harmonic current emissions

EN61000-3-3:2013 Electromagnetic Compatibility - Part 3-3: Limitation of voltage changes, voltage uctuations and

icker in public low voltage supply systems.

EN55103-2: 2009 (E2) Electromagnetic Compatibility - product family standard for audio, video, audio-visual and

entertainment lighting control apparatus for professional use - part2: Immunity

Warning: Any modication or changes made to this device, unless explicitly approved by Harman, will

invalidate the authorisation of this device. Operation of an unauthorised device is prohibited under Section

302 of the Communications act of 1934, as amended, and Subpart 1 of Part 2 of Chapter 47 of the Code of

Federal Regulations.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to

Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in

a residential installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed

and used in accordance with the instructions, may cause harmful interference to radio communications. However,

there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful

interference to radio or television reception, which can be determined by turning the equipment off and on, the user is

encouraged to try to correct the interference by one or more of the following measures:

* Reorient or relocate the receiving antenna

* Increase the separation between the equipment and the receiver

* Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

Parts of the design of this product may be protected by worldwide patents.

Rev 1.1

E&OE October 2017

Soundcraft is a trading division of Harman International Industries Ltd. Information in this manual is subject to change

without notice and does not represent a commitment on the part of the vendor. Soundcraft shall not be liable for any

loss or damage whatsoever arising from the use of information or any error contained in this manual. No part of this

manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means, electronic,

electrical, mechanical, optical, chemical, including photocopying and recording, for any purpose without the express

written permission of Soundcraft.

Harman International Industries Limited

http://www.soundcraft.com