Owner's Manual

7 FADER

The 60mm FADER gives you smooth control of the overall signal level in the channel

strip, allowing precise balancing of the various source signals being mixed to the Master

Section. It is important that the input level is set correctly to give maximum travel on the

fader which should normally be used at around the “0” mark. See the “Initial Setup”

section on page 22 for help in setting the right level.

8 PFL

When the latching PFL switch is pressed, the pre-fade pre-mute signal is fed in mono to

the headphones, control room output and meters, where it replaces the MIX. The PFL

ACTIVE LED on the Master section illuminates to warn that a PFL is active. The Left

and Right meters display the PFL signal in mono. This is a useful way of listening to any

required input signal without interrupting the main mix, for making adjustments or tracing

problems.

9 CHANNEL PEAK LED

This LED will light when the signal level approaches clipping at any of the three monitored

points:

a) PRE-EQ

b) POST-EQ

c) POST-FADE