User Manual

Lexicon® FX PROCESSOR

The effects within the console have been designed with both live sound reinforcement and home recording in

mind. Featuring the deep, rich reverb algorithms that Lexicon® are renowned for the effects processor offers

increased versatility and high quality effects, all instantly accessible via the extremely intuitive front panel

controls. The effects processor has 32 programs which are held in two banks of 16 programs which can be

stored to allow you to create your own custom effect settings.

Front panel controls include a Program Select knob, Tap Tempo and Store buttons, and three independent

‘Adjust’ knobs that provide instant access and control over the most critical parameters for the selected

effect. The table on page 30 lists the functions of the Parameter knobs for each fx program.

Note: When the console is powered up the program recalled will always be the selected program in BANK A.

FX OPERATION

Select and Load a Program

Turn the Program Select knob to choose a program. Note that the console has 32 programs which are held

in two banks of 16 programs. There are individual BANK A and BANK B LED’s to indicate which bank is

currently active. When turning the rotary Program Select knob through 360 degrees (a full rotation) the

selected bank will alternate between BANK A and BANK B.

Set Audio Levels

1. Set the gain on the input channel appropriate to the source (vocal microphone, guitar, keyboard, etc.).

2. Set the FX Master level to the 12 o’clock position.

3. Set the FX Send level on the appropriate input channel to the 12 o’clock position.

4. Provide source signal (by speaking or singing into the microphone, playing guitar, keyboard, etc.) on the

selected channel.

5. Turn up the FX Send level on the channel until the Red CLIP LED in the FX Panel lights only occasionally. If

the red Input LED stays lit, too much signal is being sent to the effect processor; reduce the FX Master or FX

Send on the input channel.

6. Adjust the required EFFECTS RETURN level controls and switches to feed the FX processor output to the

Mix/Sub and/or Aux1/Aux2 busses.

7. To increase or decrease the amount of effect on the signal, adjust the FX Send level on the channel that you

want affected.