Operation Manual

User Manual

6.2.1: MIX OUTPUTS SETUP

CHANNELS & BUSSES > MIX OUTPUTS > SETUP

6.2.1: CHANNELS & BUSSES > MIX OUTPUTS > OUTPUTS SETUP

Name

Name the selected Mix Bus.

When the Name ﬁeld is selected, a QWERTY keyboard will appear on the Touch Screen so you can enter the desired

name.

Isolate

Isolate the Mix Bus Master Channel from automation playback.

When a new cue is loaded, this channel will not be aected and its setting will not be changed. However, current

channel settings are still stored when a cue is stored.

Mix Width

Select Mono or Stereo width for this Mix Bus.

Note, only Mix busses 7-14 can be switched to stereo. Mix busses 1-8 are mono only.

There are various Mix Output-specic options, found via the Touch Screen Main Menu OUTPUTS & DMX

button (when an Output Channel is selected). These offer channel naming, isolate, LR / LCR panning and

routing Pre/Post routing options, width (stereo/mono) and physical output patching.

Pan Mode

Set Pan mode for this channel to LR (Left Right) or LCR (Left Centre Right).

Routing/Panning for the Main Mix Bus. In LCR mode the Main Mono Mix Bus is used as the Centre channel. Mono

routing must be enabled in the ACS (Assignable Channel Strip) OUTPUT section for this to work.