Operation Manual
16, 22, 22MTK User Manual
5.1.2: STEREO INPUT CONTROLS
CHANNEL CONTROLS > STEREO INPUT CONTROLS
5.1.2: STEREO INPUT CONTROLS
TRIM
Adjust the input level (highest-numbered stereo channel only)
This gives a adjustment range suitable for the typical stereo line-level source for this channel, such as a consumer
playback device.
Aux 1, 2, 3, 4/FX, 5/FX.
Adjust the level of this channel's contribution to the Aux send busses.
The Aux controls on a stereo input channel work in the same way as for a mono input channel. Please note, how-
ever - a stereo input channel's contribution to an auxiliary bus is a mono sum of the channel's left/right signals
AUX 1-2 PRE/POST
Switch Aux 1 and 2 sources post- fader for the Playback Channel only
The highest-numbered stereo input channel Aux 1 and 2 sends can be individually switched post-fader. This is
useful where, for example, the Aux 1/2 outputs are being used for pre-fade stage monitors. By switching the
‘playback’ (incidental of interval music for example) to post-fader, musicians will be able to hear the playback
music when it is faded up, and still allow the console operator to hear the channel on PFL without it being heard
in a monitor.
PAN/BAL
Adjust Pan or Balance (stereo position or relative Left/right levels)
When the stereo input channel is being used as a mono input channel (no Jack in the channel's Right input), the
Pan/Balance control acts as a Pan control (levels to left and right or odd/even groups proportional to the control's
position), which will change the stereo position of the single source. Otherwise, the control is a Balance control,
which adjusts the relative levels of the left and right signals - eectively adjusting the left-right position of the
overall stereo image.
There are two types of Signature Stereo Input Channels. The normal type has two jack inputs,
normalised so that a single jack or microphone input will operate as a mono input channel (Balance
becomes Pan). NOTE: Controls common to all input channel types are shown in the Mono Input Chan-
nel control list - 5.1.1