User's Manual

Radio Key

RK-65K Operating Guide

Secura Key  18

Using the RK-65K as a Wiegand Output Reader

(RK65K/RK100M)

The RK-65K can be connected to a multidoor access control

system (such as the Secura Key SK-ACP) using the Wiegand

output. When any Radio Key

transponder is presented to the

unit, whether or not it has been programmed into the unit, the

appropriate transponder ID will be sent out via the white and

green wires.

Program the Input (RK65K/RK100M)

The input is set at the factory as a Remote Open input.

Connecting the brown and the orange wire (usually with a push

button switch) will activate the relay for the time set for the latch

timer. This input may also be conﬁ gured as an LED control or

as an LED/beeper control. When conﬁ gured as an LED control,

grounding the brown wire will turn on the Red LED, grounding

the orange wire will turn on the Green LED and grounding the

yellow wire will turn on the beeper.

To conﬁ gure the input, put the unit into the Program mode,

(See Page 8). Press THRU TWICE. Then press either the “1”

or “2” button. Press ENTER. Selections are:

“1” - Remote Open (Factory default).

“2” - LED Control.