Operation Manual

5
IMPORTANT SAFETY INSTRUCTIONS
CAUTIONS
•
To avoid the risk of fire, replace the mains fuse only with the correct type
and value fuse, as marked on the rear panel.
•
ATTENTION: - Afin de réduire le risque de feu remplacer seulement avec
fusible de même type.
•
MAINS VOLTAGE SELECTION
This setting is NOT User Adjustable.
This unit is capable of operating at either 230V AC or 115V AC mains voltages ±10%,
which are set at the time of manufacture and marked on the rear panel. It is important
to ensure that the correct mains voltage is present at your mains outlet and that the cor-
rect fuse is fitted before switching on the unit.
To change the mains operating voltage, refer to qualified service personnel.
•
REPLACING MAINS FUSE
Switch the ON/OFF switch to the OFF position. Remove the mains lead from
the connector. Use a small screwdriver to unscrew the fuse carrier from its location
to the left of the mains power connector. Check the fuse is of the correct type and
value and replace if necessary; also check that the voltage selection as marked on
the rear panel is correct for the mains supply level before switching the unit ON again.
If the mains fuse fails repeatedly this may be because an electrical safety
hazard exists. The unit must be taken out of service and referred to the
Soundcraft dealer from where the equipment was purchased.
•
THIS UNIT MUST BE EARTHED
Under no circumstances should the mains earth be disconnected from the
mains lead.
•
ATTENTION: - Cet appareil doit être branché à la terre.
•
The wires in the mains lead are coloured in accordance with the following code:
Replacement Part No: FJ8016 (UK) : FJ8017 (EU) : FJ8018 (US & CAN)
UK & EU
US & CAN
Earth / Ground: Green and Yellow Green and Yellow
Neutral: Blue White
Live: Brown Black
As the colours of the wires in the mains lead may not correspond with the coloured
markings identifying the terminals in your plug, proceed as follows:
The wire which is coloured Green and Yellow must be connected to the terminal in
the plug which is marked with the letter E or by the earth / ground symbol:
The wire which is coloured Blue or White must be connected to the terminal in
the plug which is marked with the letter N.
The wire which is coloured Brown or Black must be connected to the terminal in
the plug which is marked with the letter L.
Ensure that these colour codings are followed carefully in the event of the plug being
changed.
•
Do not install near any heat sources such as radiators, heat resistors, stoves, or other
apparatus (including amplifiers) that produce heat.
9