Operation Manual
Soundcraft Vi Series™ User Guide 1112Page 11 - 12
* Soloing an Output generates a normal Output AFL Solo, the same as if SIP Mode was OFF. The
Output signal is switched onto the Solo Bus and the Monitor section switches so that the Output
Solo audio is heard on the Monitors, replacing the previous monitor source, if any.
Solo Operation Logic
Activating Solos
A Solo is activated when any Solo/Sel switch on the console is pressed, as long as the following is true:
* Gang Mode is not active
* VCA or Mute Group Setup Cong page is not open
Clearing Solos
* All active Solos can be cleared by pressing the momentary Solo Clear switch in the Master
Section of the console (see Figure 11-9 ). This switch illuminates when any Solos are active.
* Solos can be switched off manually.
* Solos can be cleared by pressing other Solos, under the rules of the Autocancel system (see
later in this chapter).
Figure 11-9: SOLO CLEAR Key