Operation Manual

Soundcraft Vi Series™ User Guide 1112 Page 14 - 9
SETTINGS
Figure 14-10: Settings Page
This page contains the general settings of the console.
POINT
The point at which the input meters measure the signals within the input channels can be globally set via
the {POINT} encoder. There are four options as shown below.
ENABLE NEXT/LAST
The [NEXT] and [LAST] keys are duplicated near the front of the desk, above the [SOLO CLR] and [GANG]
keys. For safety these duplicated keys are normally not enabled, and have to be switched on via the {NO/
YES} key. Once the keys have been enabled this will be stored when the show is saved.
DEACTIVATE FADER TOUCH
If strong RF Fields are present (such as from a nearby MW radio transmitter), the operation of the fader
touch sensors may be affected. The Fader Touch can be deactivated, to allow the faders to function without
interference. The Fader Touch is set to deactivated as the factory default.