Operation Manual

Soundcraft Vi Series™ User Guide 1112Page 25 - 6
Using the Console’s HiQnet Setup page to set up an IP conguration
Press the MENU button, select the System tab, then the HiQnet tab to access the Setup page.
Conguring the IP Address
Ensure the console’s HiQnet port is connected to the HiQnet network, and use the IP Cong and IP
address controls to set up a valid IP address for the console.
If you wish to set the IP address and subnet manually, set the IP CONFIG Vistonics control to ‘MAN’. Use
the IP ADDRESS and SUBNET MASK Vistonics controls to enter a valid conguration and then press the
‘SET’ button within the IP CONFIG control.
The available ranges of valid IP addresses are listed below:
Note: Some IP addresses within the ranges show are not allowed due to conicts with other parts of the Vi
system – they will be greyed out and not available for selection.
10.0.0.0 - 10.255.255.255
172.16.0.0 - 172.31.255.255
192.168.0.0 - 192.168.255.255
If you are using a DHCP server to automatically congure the IP setup, set the IP CONFIG Vistonics control
to ‘DHCP’. Wait for several seconds until an IP address appears in the IP ADDRESS Vistonics control elds.
When a valid address is established you will also see it on the far left of the HiQnet page.
At this stage, all the controls in the HiQnet Vistonics section will be greyed out, indicating that HiQnet is
disabled.