Operation Manual
Soundcraft Vi Series™ User Guide 1112 Page 25 - 19
That means that the device has the wrong IP address and subnet. - See FAQ
6-1
- Now you can check the Use DHCP checkbox if you want to use a DHCP server
for getting a valid IP address and subnet from the DHCP server
- Configure your PC operating system for retrieving automatically an IP address
and subnet – See FAQ 14
- Or you type in a static IP address and subnet by hand, for example IP address
192.168.1.10 and subnet 255.255.255.0. See FAQ 6-2.
- Click OK and your HUB 4000 Q should have now the right IP address and
subnet. The PC and the HUB 4000 Q should be now in the same subnet and
should have valid and unique IP addresses
- Now the HUB 4000 Q should show up at Readdress Devices panel. The HUB
4000 Q is now configured right and should show up also at the HiQnet Explorer
and can be used at the Venue View
Please also refer to System Architect Online help for further information on how to
set-up a HiQnet
TM
network.
Chapter ‘Troubleshooting’ – Section ‘Missing Devices’
FAQ 4: If my HUB 4000 Q is shown at Venue View, System Architect asks me
to perform a firmware update of my HUB 4000 Q.
If you have downloaded a new version of System Architect and start System Architect
and a HUB 4000 Q is detected you have to perform a firmware update.
Mixed configurations of an old HUB 4000 Q firmware together with the newest System
Architect versoin are not supported. It is recommended to use always the latest
version of System Architect which also includes the latest versions of HUB 4000 Q
firmware.
Please download the latest version of System Architect from
http://hiqnet.harmanpro.com/downloads.php
FAQ 5: What is the IP address range of the HUB 4000 Qs AutoIP?
The IP range for the Auto IP function of the HUB 4000 Q is 169.254.1.1 to
169.254.254.255 with a subnet mask 255.255.0.0.
April 2011 Page 5
HUB4000Q–FAQ