Operation Manual

Soundcraft Vi Series™ User Guide 1112 Page 5 - 7
INPUT BAY STRIP USING [ALL BUSSES]
The second method of controlling, and changing the parameters of, the 32 output busses described
earlier is as follows.
If the [ALL BUSSES] key is active (see Figure 8-6), the input strips on all of the input bays will be switched
to control the 32 output busses.
Once this is done, the user can select the desired fader to control the required output level. In addition,
the VST encoders can be used to change the bus type (Aux, Grp or Mtx) and format (Mono or Stereo).
In order to change the parameters for EQ, Dynamics or Pan, the appropriate area on the touch-screen
above the required strip must be pressed; doing so will open a page similar to Figures 5-9, 5-10 or 5-11.
In the case of Vi4 and Vi2, not
all of the busses will be visible at
the same time in the All Busses
layer, due to the limited number
of faders. In this case, the Output
Meter screen can be touched to
bring the selected 8 busses onto
the far right-hand fader bay.
(In fact this method of selecting
busses onto the right-hand fader
bay also works in Input fader
pages, not only for All Busses).
Figure 5-5.Input Bay Strip With
[ALL BUSSES] Active.