Operation Manual

Soundcraft Vi Series™ User Guide 1112 Page 7 - 1
ENCODERS
GENERAL INTRODUCTION
Each input channel strip contains three encoders (see Figure 7-1A): encoder 1 & encoder 2 are located
in the VST elds in the lower screen area, the channel encoder is located at the top of the fader area, and
has an LED ring to indicate its parameter state. Each of these encoders can control different parameters,
depending on the settings of other parts of the console.
The master section has 16 VST encoders and 4 panel-mounted encoders with LED rings (see Figure 7-1B):
the TB/OSC Level Control encoder, and the Solo Blend, Solo Trim & Phones Volume encoders. These last
four are dedicated to their respective functions.
Figure 7-1B: Master Section Panel Encoders.Figure 7-1A: Input Channel Strip Encoders.