Operation Manual
DAB500 / English Instruction Manual
2
DAB mode
Press the STANDY button to turn the unit on, it will automatically enter into the DAB mode and
perform auto scan function, During the scan the display show “Scanning…” together with a slide
bar that indicates the progress of the scan and the amount of stations that have been found so
far.(F.1) (F.2)
Once the scan has finished, the radio will select the first alphanumerically found station. You
can now press the TUN/CH
or TUN/CH
button to explore the found stations followed by
pressing the SELECT button to select listening to the stations.
Note: If there is no stations found after auto scan, the radio will then enter into the Tune Select
Menu, you can now press the TUN/CH
or TUN/CH
button to select “Manual tune” or “Full
scan” for stations.
F.1 F.2
FACTORY RESET
If moving the radio to another location in the country the pre-tuned and stored DAB stations may
no longer be available and it will be necessary to reset the radio back to the factory settings.
1. Connect the radio to AC mains (via AC/DC adaptor), then press STANDBY to turn the radio
on
2. Press and hold the MENU/INFO button for longer than 2 seconds,
then press MENU/INFO button, press the TUN/CH
or
TUN/CH
button to until the display show “system”, then press
the SELECT button
3. Continue press the TUN/CH
or TUN/CH
button until the
display shows “<Factory Reset>” and then press the SELECT
button to confirm.
4. The display is now showing “Factory Reset <No> Yes’ and Rotate
press the TUN/CH
or TUN/CH
button to confirm “<Yes>” and press the SELECT button
again.
5. The radio will display “Restarting….” and will then go into standby mode.
Note: All stored programmed stations will be lost during reset.
TECHNICAL SPECIFICATIONS
DAB frequency: Band III 174-240MHz
FM frequency: 87.5 – 108 MHz
DC Battery supply: 6V 4x UM-3/AA 1.5V Batteries
DC Power supply: DC 6V 0.5A
Specifications are subject to change without further notice.
Copyright by Wörlein GmbH