User Manual

ICD1010 / English Instruction Manual
11
SETTINGS
• Scan settings
Choose FM at first, it will go to a specific station playing. Then press “MENU” on the radio to get
above table.
By default, FM scans stop at any available station. This may result in a poor signal-to-noise ratio
(hiss) from weak stations. To change the scan settings to stop only at stations with good signal
strength, select “Yes” after choosing Strong station only.
• Audio settings
All stereo stations are reproduced in stereo. For weak stations, this may result in a poor signal-
to-noise ratio (hiss). To play weak stations in mono, select FM weak reception: Listen in mono
only and then “YES”.
CD
Notice!
Improper operation can result in material damages!
Do not insert any recording media that deviate from the standard CD format (eg: mini-discs) into
the CD player. These may not be played and ejected correctly. Insert only one disc at a time
into the CD player.
Open the CD tray by pressing the “ “ button and put a disc (with printing side facing to you)
inside. Close the CD tray with the “ “ button. The display will say “Loading” and the disc
functions will not work while the disc is loading. After reading the display shows the following
information in CD mode:
• Folder
• Track
• Current Play time
• Playback status (playing/pause)
The Playback will begin automatically once the table of contents is read. The display will show
“No Disc” when the unit is set to CD mode and there is no CD inside.
• To pause/resume playback of the CD, press the “ ” button
• To switch to the next track, press the “ ” button once
• To fast forward through a track, press and hold the “ ” button.
• To switch to the previous track, press the “ ” button twice
• To fast backward through a track, press and hold “ ” button.
• To stop CD playback, press the “ ” button on the remote control.
• To eject the disc press in stop mode the “ ” button on the unit.