User Manual

MCD1820 / English Instruction Manual

Encoding bit rate (by remote control)

You can select the desired bit rate for encoding to USB or SD, the selectable range from 32 /

64 / 96 /128 / 192 / 256 kbps.

1. Set in “PHONO/AUX“ or “TAPE” function.

2. Press “DELETE / INFO“ and the LCD display will show the default bit rate (128 kbps).

3. Press “ TUNE –“ or “ TUNE +” to select the desired bit rate for encoding.

4. Press again “DELETE / INFO” button to confirm the setting and the LCD display resume to

“Phono/Aux“ mode.

File delete at USB / SD card (by remote control)

The system is able to erase the file stored inside the USB pen drive or SD card by following:

1. Insert the media storage and set at “USB“ or “SD“ mode.

2. Press the “DELETE / INFO“ button and the LCD display will show (del ---001).

3. Press “ TUNE –“ or “ TUNE +” to select the file going to delete.

4. Press “DELETE / INFO” to enter “Yes / No“ selection and then “ TUNE –“ or “ TUNE +”

to select “Yes“ or “No“.

5. With “DELETE / INFO” button, confirm the setting.

Remark :

Press “ / ENTER“ button once at remote control to quite delete mode.

Removing of USB / memory card

To remove the USB / memory card, turn off the power or switch the function mode to either CD,

Tape or Radio first. For USB port – un-plug it by pulling out the USB socket directly, for memory

card – pull out the SD/MMC card straightly without bending.

TAPE

General operation

Cassette playback : The system will start the playback automatically after inserting

of cassette tape

Stop and ejection : Press the “Tape forward / Eject“ button completely inwards

and the cassette tape will be ejected though the cassette door cover. The

“Tape forward / Eject“ button will keeping at lowest height position.

Fast forward : Press the “Tape forward / eject“ button half inwards during playback

mode, the tape winding forward direction. The “Tape forward / Eject”

button will keeping at middle height position.

Slightly press the “Tape forward / Eject“ button again to resume normal

playback. The “Tape forward / Eject“ button will resume to the highest

position.

Remark

- Make sure the direction is correct when inserting the tape into the system.

- There is some searching noise can be heard and the system cannot perform normal

playback function during fast forward mode.

- This is recommended to take out the cassette tape from the system every time after

listening and don’t leave the cassette tape inside the system when not under playback

mode.