User Manual

M_MCD5500SW
/
English Instruction Manual
4
Recall preset stations
1. Press the Mem/Clock-Adjust button (12) once to enable recall state
2. Press Folder/ Pre up button (22) to select the desired memory station.
3. Press Memory/Clock-Adjust button (12) to confirm the recall memory station.
¾ The pre-set memories will be cancelled completely if dis-connecting the main power supply and back up battery did not
installed. You are recommended to switch the system into standby mode for convenience usage.
¾ There are 3 seconds for program state, after 3 sec, this state would resume to normal tuner mode automatically.
¾ You can overwrite a present station by storing another frequency in its place.
FM-Stereo reception
z Press the “Enter” knob (3) repeatedly; the FM programs are receiving in mono and stereo mode repeatedly. In particular
when stereo signals are weak, it is preferable to receive the program in Mono.
z If stereo signal is being received, the stereo indicato
r “ ” will appear on LCD display (2) to show FM Stereo program is
now receiving.
Hints for best reception:-
-
FM : the receiver work with detachable DAB/FM wire antenna, made sure the antenna had plugged into the antenna socket
(30) and place it on proper location for the best reception.
Playing Compact Disc
z Getting start
1. Press Function button (10) to select “CD” mode.
2. Push the CD tray open (25) to open the CD tray.
3. Place a CD with the printed side facing up and then close the CD tray.
4. Focus search will perform and the LCD display (2) will show the total number of tracks & total playing time. Then, the unit will
start automatically.
5. Turn Volume knob (19) to the desired volume level.
z Play/Pause mode
1. To interrupt, press the “Play/Pause ” button (16) once; “PAUES” will show on the LCD display (2). Press again to resume
normal playback.
z Stop mode
1. If “Stop ” button (3) is pressed during play or pause mode, system will go to stop mode.
z Skip mode (skip up /skip down )
1. During play or pause mode, if “skip up ” button (23) is pressed. It will go to next track and display the track no. and then
remain the play or pause mode.
2. During play or pause mode, if “skip down ” button (13) is pressed. It will go to the previous track, original track no. is
display and remains the play or pause mode.
z For MP3 Disc
1. After focus search is performing, the total number of track and album will be shown on the LCD display (2). The unit will start
to plat directly.
2. Turn “Folder/Pre up /down ” knob on the remote control to select the folder number.
3. Press “Skip Up or Skip Down ” button (23/13) to select the track number.
ID3/Display function (on remote control only)
Press the “Info” button repeatedly, the LCD display (2) show “file” during playback of MP3 file, the song file/album/song/artist
name is being displayed few seconds in sequence. Then will change back to current clock time.
Remark:-
- In that case of no name or not supportive languages had been assigned for the track, LCD display will blank (2) when press
the Info button.