User Manual

M_MCD5500SW
/
English Instruction Manual
8
1. Select to “Phono” function (10).
2. Set the speed selector (27) to the proper position depending on the record to be played.
3. Place the record on the platter (use the spindle adaptor (26) if required).
4. Lift the tone arm from the rest and slowly move it to the record side. The platter will start to
rotate.
5. Place the tone arm to the desired position of the record.
6. Adjust the volume to the desired level (19).
7. At the end of record, the platter will automatically stop rotating. Lift the tone arm from the record and return it to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
Remark: as some kind of record the auto-stop area was out of the unit setting, so it will stop before the last rack finish. In this
case, select the auto-stop switch to “off” position, then it will run to the end of the record but will not stop automatically (turn off the
power button or switch back the auto-stop switch (28) to “on” position to stop the platter rotate). Then put back the tone arm to the
rest position.
Listing to tape
General operation
Stop/eject key press to stop all deck operation. Press again to open the cassette door.
Fast forward key & Fast
rewind key
press to start rapid tape winding in either forward or reverse direction. Press stop / fast rewind key
eject keys when the cassette spools stop turning.
Play key press to start playing tape.
Pause key press to stop tape operation temporarily. Press again to resume play.
Playback
z Select “tape” function (10).
z Put in the cassette tape.
z Press play key to active playback
z Adjust the volume control (14/24) to the desire level.
z Use pause key when you want to stop playback temporarily.
z Press stop/eject key when finished.
Remark:
It is possible to play both cassette players one after the other. If you press the button “pause” and “play” at deck 1 and button
“play” at deck 2, than the tape of deck 1 will be start to play automatically after the tape of deck 2 is finished.
More features
A. Sleep function (on remote control only)
1. Press “Sleep” button on remote control, “SLP-120” will be shown on the LCD display (6).
2. Keep pressing the button to adjust the sleep timer in the order of 120>90> 60 > 45 >….15 minutes respectively and sleep
icon “ ” will indicate on LCD.
3. System will stop and go to standby mode automatically after running the selected time.
4. To cancel the sleep mode, press “Sleep” button until “SLP-off” is displayed and the “ ” indicator disappear on LCD display.
B. Timer clock setting (on remote control only)
This function allows the system to turn on automatically and wake you up by CD, DAB, FM Radio, USB/SD mode respectively.
First, set the unit at standby mode and then press & hold the “Timer” button on the remote control to enter the setting mode, the
LCD display will show “SET TIMER”; then change to “SELECT SOURCE” and timer “ ” icon will flash on display :-
1) Wake up source
press the “Function” button repeatedly to select the source from “CD” -- “FM” -- “DAB”-- “USB” –“SD”.
Press “Timer” button to confirm the selected source.