Operation Manual

SAFETY INSTRUCTIONS
E-2
1. READ INSTRUCTIONS - All the safety and operating instructions should be read before the appliance is operated.
2. RETAIN INSTRUCTION
S - The safety and operating instruction should be retained for future reference.
3. HEED WARNING
S - All warnings on the appliance and in the operating instructions should be adhered to.
4. FOLLOW INSTRUCTION
S - All operating instructions should be followed.
5. WATER AND MOISTUR
E - The appliance should not be used near water, for example, near a bathtub, washbowl,
kitchen sink, laundrytub, swimming pool or in a wet basement.
6. VENTILATION
- The appliance should be situated so that its location or position does not interfere with its proper
ventilation. Do not place on bed, sofa, rug or similar surface that may block the ventilation openings, in a built-in
installation, such as a bookcase or cabinet that may impede the flow of air through the ventilation openings
.
7. HEA
T - The appliance should be situated away from heat sources such as radiators, stoves, or other appliances
(including amplifiers) that produce heat
.
8. POWER SOURC
E - The appliance should be connected to power supply only of the type described in the
operating instructions or as marked on the appliance
.
9. GROUNDIN
G - Precautions should be taken to ensure that the grounding means of an appliance is not defeated.
10. POWER CORD PROTECTIO
N - Power supply cords should be routed so that they are not likely to be walked
on or pinched by items placed upon or against them
.
11. POWER LINES
- An outdoor antenna should be located away from power lines.
12. OBJECT and LIQUID ENTRY
- Care should be taken so that objects do not fall and liquids are not spilled into
the enclosure through openings
.
13. ESD WARNIN
G - The display does not function properly or no reaction to operation of any the control may due
to the electrostatic discharge. Switch off and unplug the set. Reconnect after a few seconds.
14. DAMAGE REQUIRING SERVICE
- The appliance should be serviced by qualified service personnel when:
a. The power-supply cord or plug has been damaged.
b. Objects have fallen into, or liquid has been spilled into the appliance enclosure.
c. The appliance has been exposed to rain
.
d. The appliance has been dropped, or the enclosure damaged
.
e. The appliance does not appear to operate normally.
15. SERVICING
- The user should not attempt to service the appliance beyond that described in the user operating
instructions. All other servicing should be referred to qualified service personnel.
Notes:
a. Dirty or scratched CD may cause a skipping problem. Clean or replace the CD
.
b. If an error display or malfunction occurs, disconncet the AC cord and remove all the batteries. Then turn the powe
r
back on.
BEFORE OPERATION
Notes: CONCERNING COMPACT DISCS.
Since dirty, damaged or warped discs may damage the appliance, care should be taken of the followings items
:
Usable compact discs. Use only compact disc with the mark shown below
.