DEUTSCH ENGLISH Hersteller Wörlein GmbH Gewerbestrasse 12 D 90556 Cadolzburg GERMANY FRANÇAIS NEDERLANDS Tel.: +49 9103/71670 Fax.: +49 9103/716712 Email. info@woerlein.com Web: www.woerlein.
BATTERY INSTALLATION The battery compartment is located on the back of the remote control. 1. Remove the battery compartment door by pressing in on the tab and lifting it off. 2. Insert two (2) AAA size batteries (not included) into the battery compartment following the polarity markings inside the battery compartment. 3. Replace the battery compartment door.
Installation of counter weight 1. 2. 3. 4. Slide in the counter weight completely into the rear of the tone arm until it reach the end, turn it clockwise until it click with pit inside. Twist the counter weight clockwise & backward until it reach the white line as figure 2 Twist the counter marking until it reach “ 1 “ position Twist the counter weight anti-clockwise & inward until it reach the appropriate working pressure.
Playing compact disc z Getting start 1. Press the Function button (5/45) to select “ CD “ mode. The LCD display will show “ busy “ and then “ no disc “ if the CD compartment is empty. Then press the CD tray open button (6) to open the CD tray (7). Place a CD with the printed side facing up inside the tray & then close the CD door. Focus search is performing and LCD display (3) will show “ busy “ and then display the total number of tracks & total playing time. 2. 3. 4. z Play / Pause mode 1.
Recording function Apart from the CD playback function, it can perform the CD recording function either from Phono / Tape / Aux and USB mode respectively. All the recording track will be stored at “ audio-CD “ format:Before start, place a CD-R or CD-RW disc in the CD tray (7). The disc is able to record only if the LD display show “ NO TOC “. Remark : CD-R disc can be recorded once only and not support erase or re-record function.
A) Auto mode Press the “ Auto/Manual “ button (43) when prepare the recording function, the LCD (3) will show -20db , -30db, -40db, the “AUTO TRACK” icon will appear on LCD“ When the recording sound level has dropped below the -20 / -30 / -40 dB (record signal) respectively, the current track will terminate and then generate a new track & continue the recording mode automatically.
Playback of MP3 song via USB storage media Connecting The system is able to decode and playback all MP3 file which stored in the memory media with USB connecting port (21). 1. 2. z 3. 4. z Set the system at standby mode first or other function except USB mode. Plug-in the USB pen-drive with the face up & make sure it going into completely or insert the memory card in the direction of the arrow as shown in the label on the underside of the memory card slot. Insert straight without bending..
z z z Press “ stop “ button (44) at USB stop mode to cancel all programmed memory. Press the “ folder / pre-up “ button (44) to select the 1st track of next folder directly and hence to speed up the song selection. The programming model will automatically stop if no button is being pressed in a period of about 10 seconds after pressing the “ mem/clk-adj “ button (44). Listing to tape General operation Select the function button (26) to select Tape mode.
Adjustments - - Anti-skating control The anti-skating control (28) is made the stylus more stable and this relative to the different type of vinyl, thus, just set it to the comfortable position as you desired.
