Instructions

SCD5800 / English Instruction Manual

RADIO

1. Select the radio mode with the “STANDBY / FUNCTION” button, until “RAD” is shown in the

display and after that the radio frequency.

2. For FM reception: Completely extend the telescopic antenna. Change its position to improve

the reception.

3. There are two options to search for and preset radio stations.

➢ Automatic scan:

Important! All preset radio stations will be overridden.

Press and hold the "SCAN / PROG" button for approx.3 seconds. The system scans the

entire frequency band for radio stations. Any stations found will be preset from lowest to

highest frequency.

➢ Manual scan for audio stations:

Briefly press the “SKIP+ / TUNING+” & “SKIP- / TUNING-” buttons, until you have found the

radio station which you are looking for. If you keep one of the buttons pressed down, the

device will search to the previous, respectively next radio station.

Preset station

1. Select the desired station.

2. Press the "SCAN / PROG" button. The display shows "P ..." and the next free memory

flashes. By repeatedly pressing the "PRE + / FOLDER +" button, you can also select a

desired memory location yourself. If a station has already been stored on this program

station, it will automatically be overwritten.

3. Press the "SCAN / PROG" button again to confirm the station to the program station.

1. Select the CD mode with the “STANDBY / FUNCTION” button, until “CD” is shown in the

display.

2. Open the CD compartment by pulling the lid upwards by the tab.

3. Insert an audio CD with the printed side facing upwards on to the central cone so that the

CD clicks into place and then close the lid of the CD compartment.

4. The CD will play from the first title.

5. In order to remove a CD, please press the “STOP” button, open the CD compartment and

lift the CD out carefully.

Always keep the CD deck closed.

For operation, please refer to the section “CONTROL BUTTONS”.

NOTE:

➢ If a disc is inserted the wrong way around, respectively if no disc is inserted, then the

message “NO “ appears in the display.

➢ Playback of self-recorded CDs can not be guaranteed due to the wide variety of available

software and CD media.