Operation Manual

TROUBLESHOOTING
8
ENGLISH
If a fault occurs, first check the points listed below before taking the set for repair.
Do not open the set as there is a risk of electric shock.
If you are unable to remedy the problem by following these hints, call service and support at the
phone number shown below.
Warning :
Under no circumstances should you try to repair the set yourself, as this will invalidate the
warranty
Problem Cause Solution
No sound / power
Volume not adjusted Adjust the Volume
Power cord not securely connected Connect the AC cord properly
Batteries dead / incorrectly inserted
Insert (fresh) batteries correctly
Display does not function properly /
No reaction to operation of any of the
controls
Electrostatic discharge
Switch off and unplug the cord. Reconnect
after a few seconds
Dust and dirt on the head, etc. Clean deck parts , etc.
The CD skips tracks
CD damaged or dirty Replace or clean CD
Program is active Quit program mode
No disc indication
No CD inserted Insert a CD, CD-R or CD-RW
CD badly scratched or dirty Replace or clean CD
Laser lens has steamed up Wait until lens has cleared
CD-R is blank or the disc is not f
inalized Use a finalized CD-R
CD Playback does not work
CD badly scratched or dirty Replace or clean CD
Laser lens steamed up
Wait until lens has adjusted to room
temperature
Poor cassette sound quality