Instructions

SCD7800 / English Instruction Manual
3
Select DAB radio station
Press the “SKIP - / TUNING -” or “SKIP + / TUNING +” and select the desired radio station.
To confirm the selection, press the “PLAY / PAUSE / CLOCK / ENTER” button.
Preset store
1. Select the desired radio station.
2. Press the “SCAN / MODE” button and choose with “SKIP - / TUNING -” or “SKIP + /
TUNING +” the desired program station number.
3. Press to confirm the “PLAY / PAUSE / CLOCK / ENTER”.
Preset recall
Press the “PRE + / FOLDER +“ button repeatedly to select the desired stored radio station.
DAB information
Press repeatedly the “INFO / SNOOZE” button to show the following DAB information:
DLS, signal strength, genre, frequency, signal error, audio bit rate, time, date.
DAB menu
To enter the DAB menu, press the “STOP / MENU” button. Select with the “SKIP - / TUNING -”
or “SKIP + / TUNING +” one of the following settings and press “PLAY / PAUSE / CLOCK /
ENTER”:
• Full scan:
Starts the station scan. The DAB frequency band is scanned for stations.
• Manual tune:
To do so you need to know the station frequency. This can be found on the internet site of
the broadcasting service. Select individual frequencies using the “PLAY / PAUSE / CLOCK
/ ENTER” button.
• DRC:
Short for Digital Range Control (dynamic range). The term DRC describes the ratio between
the quietest and the loudest sound. If the dynamic range is very high there are very soft
sounds as well as very loud sounds.
Under some circumstances this may present a problem with playback. Let us assume that
you are listening to a radio station in a relatively loud environment. By increasing the volume
you can play the quiet sections louder.
This however has the disadvantage that the loud sections become uncomfortably loud. It
makes sense here to reduce the dynamic range. Select between the options:
- DRC off: The dynamic range is not reduced.
- DRC high: The dynamic range is sharply reduced.
- DRC low: The dynamic range is slightly reduced