Operation Manual

ManualsBrandsSoundmaster ManualsAudioUR1001

URUR1001 / English Instruction Manual

1. PROJECTOR

2. DISPLAY

3. FUNCTION

4. ON / OFF

5. ALARM 1 BUTTON

6. ALARM 2 BUTTON

7. MEM / TIME BUTTON

8. << / TUNE –

9. >> / TUNE +

10. VOLUME -

11. VOLUME +

12. NATURAL SOUND SELECTOR

13. MEM +

14. DIMMER / SNOOZE / SLEEP

15. PROJECTION ON/OFF BUTTON

16. PROJECTION TIME 180° FLIP BUTTON

17. FOCUS ADJUSTMENT FOR PROJECTION UNIT

18. RESET BUTTON

19. DC IN JACK

20. AUX IN JACK

21. FM Antenna

22. BATTERY COMPARTMENT (REAR OF UNIT)

23. RATING LABEL (REAR OF UNIT)

Summary of content (5 pages)

PAGE 1
URUR1001 / English Instruction Manual 1. PROJECTOR 2. DISPLAY 3. FUNCTION 4. ON / OFF 5. ALARM 1 BUTTON 6. ALARM 2 BUTTON 7. MEM / TIME BUTTON 8. << / TUNE – 9. >> / TUNE + 10. VOLUME 11. VOLUME + 12. NATURAL SOUND SELECTOR 13. MEM + 14. DIMMER / SNOOZE / SLEEP 15. PROJECTION ON/OFF BUTTON 16. PROJECTION TIME 180° FLIP BUTTON 17. FOCUS ADJUSTMENT FOR PROJECTION UNIT 18. RESET BUTTON 19. DC IN JACK 20. AUX IN JACK 21. FM Antenna 22. BATTERY COMPARTMENT (REAR OF UNIT) 23.
PAGE 2
UR1001 / English Instruction Manual AC-DC adaptor connection: The clock radio unit can be powered by an external AC-DC adaptor, required the output DC 5V 500mA (included). POWER CONNECTION Plug the AC/DC Adaptor to a household outlet AC source, connect the adaptor’s DC output plug to the DC-in jack of the clock unit. This unit is equipped with a battery back up system, it requires a 3V CR2032 flat lithium battery (not included).
PAGE 3
URUR1001 / English Instruction Manual Switching the alarm on/off 1. To switch the alarm (alarms) on press and hold the ALARM 1 (5) / ALARM 2 (6) button until the bell symbol appear on the display. 2. To switch the alarm (alarms) off again press and hold the same button. ALARM SNOOZE 1. You can switch off the alarm signal for 9 minutes by pressing the DIMMER/SNOOZE/SLEEP button (14). In 9 minutes the alarm signal will be repeated. 2.
PAGE 4
UR1001 / English Instruction Manual TIME PROJECTION 1. To project the image of current time, turn the projector (1) in the necessary direction. Switch on the projector by pressing the PROJECTION ON/OFF BUTTON (15) 2. To focus the projected image, rotate the FOCUS ADJUSTMENT button (17). 3. To turn the projected image to 180°, press the 180° FLIP button (16). 4. To switch off the projector, press the PROJECTION ON/OFF BUTTON (15). Note: project time image on the ceiling or wall of a darkened room.
PAGE 5
URUR1001 / English Instruction Manual WARNING 1. No naked flame sources, such as lighted candles, should be placed on the apparatus. 2. Do not place the product in closed bookcases or racks without proper ventilation. 3. Where the mains plug is used as the disconnect device, the disconnect device shall remain readily operable. 4. The ventilation should not be impeded by covering the ventilation opening with items, such as newspapers, table-cloths, curtains, etc.. 5.