Operation Manual

Press down the compartment cover, and slide
the cover off to open the compartment. Place the
two (Um3), (AA), (R6) batteries in the remote
control according to the polarity markings ("+" and
" - ") inside the compartment and on the batteries.
Place the cover over the compartment, press down
lightly, and push it upward until it snaps on.
NOTE : Remove the batteries from the remote
control if not in use for long period of the time.
Do not mix normal batteries with rechargeable
batteries, when the batteries become weak,
remote control will not function and replace with
new batteries.
OPERATING THE UNIT
When you first plug the unit into the AC outlet, the unit will be in standby mode , You can press the
POWER/STANDBY button on the unit ( or on the remote control ) to switch the unit ON or OFF. Pull the AC
plug out of the wall socket if you want to switch off completely.
POWER/STANDBY
1. Press POWER/STANDBY button on the unit (or remote) to switch the unit on.
2. Select the sound source (CD, USB, or TUNER) by pressing FUNCTION button.
3. Adjust the volume with the VOLUME (UP or DOWN) button.
4. Press POWER/STANDBY button again to turn off the unit.
CLOCK SETTING
Function switch on STANDBY position
1. Press & hold DISPLAY / CLOCK SET button until the time appear 24H digit flashing.
2. Press TUNING / SKIP / SEARCH (UP or DOWN) button to adjust 12-hour or 24-hour digit.
3. Press DISPLAY / CLOCK SET button again, the time display HOUR digit flashing, press
TUNING / SKIP / SEARCH (UP or DOWN) button to adjust HOUR digit; Press
DISPLAY / CLOCK SET button once more, the MINUTE digit flashing, adjust it by the
SKIP/SEARCH/TUNING (UP or DOWN) button.
4. Press the DISPLAY / CLOCK SET button again to confirm the time.
5. In the unit ON mode, you can press this button to display the current time.
6. Each enable state as shown above will be cleared if the key is not pushed in 10 seconds.