Operation Manual

MMI of UR2060
3.7 Using Aux function
•
Tune on your sound source device, connect audio cable with 3.5mm jack from source
device output into hole of “ AUX”
•
Select output levels refer to “3.5 Output level control” to select a sound output you want.
•
Control your source device to play back it.
3.8 Output Level control (Electronics Volume Control)
•
When radio, CD or Aux was on,
•
Press <VOL+> once, to increase speaker volume by one step. Hold for continually.
•
Press <VOL-> once, to decrease speaker volume by one step. Hold for continually.
Protect your ear, don’t make it too loud!
3.8 Battery Backup( Battery not include)
•
Open cover of battery compartment.
•
Place battery into compartment, tune clockwise to close and lock door.
•
The backup battery will keeping preset data and clock running.
3.9 LCD Dimmer
•
At the any mode, press <Dimmer> 2 seconds to select dimmer On or dimmer Off.
•
Select dimmer On with turn on the back light, select dimmer off with turn off the back light.
3.10 Key-lock
•
Press and hold the <Lock>, key-lock has been switched ON, the “KEYLOCK” goes solid.
•
Press and hold the <Lock> for 3 seconds again, key-lock has been switched Off, the
“KEYLOCK” goes off
3.11 Using Remote
•
Press each button same as unit to control the device.
10 Of 10
VER:R0