Operation Manual

Press the CLK.ADJ/PROG. button and then the CD PLAY/PAUSE button to begin

programmed playback again.

y To clear the program from the memory after the disc stops, press the CLK.ADJ/PROG.

button and then press the STOP button.

Opening the CD door, pressing the ALARM OFF/POWER button to shut the unit off, or by

switching to the RADIO function also clear the program.

Adjusting The Wake-Up Times

This clock radio has two separate wake-up alarms that can be set and used independently. To

set or adjust the wake-up times please proceed as follows:

1. Depress and hold the ALARM SET/DISPLAY button for at least two seconds until just the

Hour digits and the AL1(Alarm 1) indicator are flashing.

2. While the Alarm 1 Hour digits are flashing press the TIME-DN/F.REW or TMIE-UP/F.FWD

buttons repeatedly to set the display to the correct wake-up hour. Example: 7:00 AM

3. When the correct wake-up hour is flashing press the CLK. ADJ/PROG. button again. The

Hour digits stop flashing and the minute digits begin to flash.

4. While the Minute digits are flashing press the TIME-DN/F.REW or TMIE-UP/F.FWD buttons

repeatedly to set the display to the correct wake-up minute.

5. When the desired Alarm 1 wake-up time is showing on the display, press the CLK.

ADJ/PROG. button to store the Alarm 1 wake-up time in the timer memory.

The AL2 (Alarm 2) indicator and the Alarm 2 Hour digits begin flashing.

Note: If you do not need to adjust the Alarm 2 wake up time you may just wait 10 seconds.

After 10 seconds the Alarm 2 display stops flashing and the clock returns to the correct time.

6. While the Alarm 2 Hour digits are flashing press the TIME-DN/F.REW or TMIE-UP/F.FWD

buttons repeatedly to set the display to the correct wake-up hour. Example: 9:00 AM

7. When the correct wake-up hour is flashing press the CLK. ADJ/PROG. button again. The

Hour digits stop flashing and the minute digits begin to flash.

8. While the Minute digits are flashing press the TIME-DN/F.REW or TMIE-UP/F.FWD buttons

repeatedly to set the display to the correct wake-up minute.

9. When the desired Alarm 2 wake-up time is showing on the display, press the CLK.

ADJ/PROG. button to store the Alarm 2 wake-up time in the timer memory. The display stops

flashing and returns to the correct time. The Alarm 2 indicator disappears.

IMPORTANT: After you press the CLK. ADJ/PROG. button you must make your wake-up time

adjustments within 10 seconds while the wake-up time display is flashing. After 10 seconds the

wake-up time display stops flashing, the display returns to the correct time, and no wake-up

time adjustments can be made. If this occurs you must begin with Step 1 above and start the

wakeup time adjustment process again.

Setting The Alarms / Selecting The Wake-up Mode

After you have adjusted the wake-up times on one or both alarms you must press the respective

ALARM 1 and/or ALARM 2 buttons one, two or three times, to activate the alarms and select

the wake-up mode.

The color of the AL1 and AL2 indicators will change according to the wake-up mode that you

select - Buzzer, Radio, or CD.

NOTE: Whichever wake-up mode you select - Buzzer, Radio, or CD – will apply to both alarms.

Press the ALARM 1 or ALARM 2 button once.

The AL indicator is Red. This indicates the Wake To Buzzer mode is selected and the alarm

is ‘On’.