SM-CCR3030 CASSETTE RECEIVER Instruction manual
Dear customer! Thank you for purchasing our product. For safety, it is strongly recommended to read this manual carefully before connecting, operating and/or adjusting the product and keep the manual for reference in the future. Table of contents Table of contents ....................................................................................................................................................................................2 Important safeguards ...........................................
Important safeguards - - Read carefully through this manual to familiarize yourself with this high-quality sound system. Use only in a 12-volt DC negative-ground electrical system. Disconnect the vehicle's negative battery terminal while mounting and connecting the unit. When replacing the fuse, be sure to use one with an identical amperage rating. Using a fuse with a higher amperage rating may cause serious damage to the unit. DO NOT attempt to disassemble the unit.
Installation/ Connections First complete the electrical connections, and then check them for correctness. Installation way It is an anti-theft installation way. The chassis wear a metal sliding housing. Please have the wiring connection of the power supply, speakers and antenna as for the requirement of the manual, and then install the metal sliding housing into the car according to the diagram.
Detaching the front panel 1. 2. Press the OPEN button on the front panel. The panel will go down (pic. 1). Push the panel to the right and then pull it towards you (pic. 2). Pic. 2 Pic. 1 Attaching the control panel 1. Insert the right side of the control panel into the main unit (pic. 3). Note: the control panel must be attached into the T-Joint. 2. Press the control panel on to the left side of middle of it until a click sound is heard. 3. Close the panel. Pic.
Speaker connection R (Red) L (White) R (Red) L (White) Notes: - In spite of having any kinds of speaker system, must use 4 ohms impedance of speaker to reduce the distortion during high volume level. - Prohibit to make the conductors of auto antenna and ground touch with each other.
Panel controls Front panel 1. OPEN BUTTON Press it to flip down the front panel to insert or eject the cassette. 2. VOL knob/ SEL button Rotate VOL knob clockwise to increase the volume level; rotate anticlockwise to decrease the volume level. Press the VOL/SEL button shortly to show the time on display. Press it and hold for 3 seconds to set the time: press the >>/+ button to adjust the hour. Press the <
4. POWER BUTTON Press the POWER or any other button to turn the power on. Press the POWER button to turn the power off. 5. << -/ >> + BUTTONS Tune down/ up / Track down/ up buttons. 6. PRESET STATION [1-6] BUTTONS 7. BND/ MODE BUTTON Press and hold for 2 seconds and then press it repeatedly to select the mode: Cassette => Radio => CD changer (if it is connected). In Radio mode press it repeatedly to select your desired radio band.
Remote control 1. Digit area 2. ST button 3. MODE button 4. MUTE button 5. SCAN button 6. CLOCK button 7. BAND LOUD button 8. POWER button 9. AS/PS button 10. LOCAL button 11. VOL SEL button 12. SEEK +/- buttons: use these buttons to enter the manual tuning mode/ seek tuning mode. Use this button to search for the beginning of the previous/ next track, for backward/ forward track scanning. 13. VOL +/- button 14. P.EQ button Changing the battery 1.
Function of controls General operations Reset the unit Operating the unit for the first time or after replacing the car battery, you must reset the unit. Press OPEN button and remove the panel, then press the RESET button to restore the unit to the original factory settings. Power button Press any button to turn the unit on. Press the POWER button on the front panel or on the RC to switch the unit off.
Radio operations Band select Press the BND/ MODE button on the front panel or BAND LOUD button or RC repeatedly to select your desired radio band during RADIO mode: FM1, FM2, FM3, AM1, AM2. Auto/ Manual tuning - Automatic tuning: Press the << -/ >> + buttons or SEEK buttons on the RC shortly, the automatic search will start. It will play when finds the station. - Manual tuning: press << or >> buttons or SEEK buttons on the RC and hold for 2 seconds to enter manual tuning. MANUAL appears on display.
Cassette operations Loading a cassette - Turn the power on. - Press the OPEN button on the panel. Insert the cassette with the exposed tape side facing right into the slot. The playback will start automatically. Play direction reverse Press both the REWIND and FAST FORWARD buttons on the back of the front panel at the same time to reverse the play direction of the tape while it is still playing. When the tape reaches to the end, it reverses automatically and the other side begins to play.
Troubleshooting guide No power or no sound Car's engine switch is not on. Turn your car's key to ACC or ON. Cable is not correctly connected. Check connection. Fuse is burnt. Replace fuse. Check volume or mute on / off. If above solutions cannot help, press the RESET button. Sound skips due to vibration Mounting angle is over 30º. Adjust mounting angle to less than 30º. Instable mounting. Mount the unit securely with the mounting parts.
Specification General. Power supply: Maximum power output: Fuse: Suitable speaker impedance: Output wiring: RCA line out: Dimensions (W x H x D)/Weight: FM. Frequency coverage: Sensitivity (S/N = 60 dB): FM mono sensitivity: Stereo separation: AM. Frequency coverage/Sensitivity: Cassette player.
! . , , . ................................................................................................................................15 ..............................................................................................................16 / ..............................................................................................................17 .....................................................................................................................20 ....................
- , . - 12 . . , . , . - . , - . , , , - , . , ( - .). . . - , - , , . , , , , . . 2 - . 4 . . . , , , . . , , , . . , , . 16 .
- 0,75 / (AWG18), . , . . , , . .
OPEN 1. 2. . ( ( . 1). . 2). .2 .1 , 1. ( , .3). , 2. 3. ( . 4). . : : . , . . . , . , . : , . , . 18 .
( ( ) ) ( ( ) ) : - , , . .
1. OPEN. , EJECT 2. / SEL . , . , VOL/SEL, 3 , >> + , . : . << - , . 5 . 20 VOL/SEL, .
3. 4. 5. POWER POWER . POWER . << -/ >> + / . 6. 7. (1-6) BND/ MODE , changer (CD 1. 2. 3. 4. )( , : Cassette ( ). . EJECT RESET / ) => Radio ( .
1. 2. 3. 4. 5. 6. 7. 8. 9. 10. 11. 12. 13. 14. . ST MODE. MUTE. SCAN CLOCK BAND LOUD: RADIO. POWER. AS/PS LOCAL SEL - . , P.EQ , VOL+/-. : 1. 2. 3. . , (CR 2025 3V), 22 . .
RESET ( ) OPEN. . . RESET, : , , . , POWER . , : . , , , . VOL/SEL -, . VOL/SEL CLOCK 3 , >> + , CLOCK, , : . << . 5 . BND/ MODE MODE , ) => Radio ( ) => CDC ( : Cassette ( CD ). , , . . VOL+/BASS ( => FADER ( , SEL ) => TRE LE ( / , . , ) => BALANCE ( : VOLUME ( / ). .
, . MUT , , . ST . EQ : POP, CLASSIC, ROCK, FLAT, BND/ MODE : FM1, FM2, FM3, AM1, AM2. BAND LOUD . , / - : << - . - . >> + , << - : . , . >> + MANUAL. , << -/ >> + , . 6 5 . : - ( - ( - , ). << -/ >> + . 1~6, . : ). 1~6.
· : AS/PS 5 AS/PS. · , . , : AS/PS , 2 1~6. 1-6. ,6 AS/PS. LOC . . SCAN - . OPEN, . . . . , . , . . . : , EJECT . . , .
- . ( ), , , . . - , . 20-30 , . , , , , . , , . , . .
. ACC ON. . . . . , . 30 , . . . 30 , . . . , . . . ( ). . . , . , 27 .
. 12 , 50 15 4 8 4 : : : ( FM RCA: )/ . . 4 RCA / 1,75 : ( : = 60 FM . ) 500 192 178 50 87,5 108,0 50 50 30 522-1620 / 20 : . 4,75 180 ( -60) 30 - 12 > 40 / > 45 < 0.35 % WRMS /Cross talk : : , . .
